Gate structure is manufactured from pre-galvanised steel SHS/RHS sections.
Material thickness is dependent on the opening width and the security requirements of the project.
SIZE
The maximum gate size is 3000mm wide in single leaf, 6000mm in Double Gate arrangements.
Height of gate tosuit fence line: standard heights 1800mm– 2400mm, higher if required.
GATE INFILL
Infill typically vertical bar utilising 25mm SHS. A range of other optionsare available including palisade, RHS, angles, barconfiguration, weld mesh, cladding or a bespoke finish to suit specific site requirements.
AUTOMATION
Automation is provided via high duty electro-mechanical gate operator.
Safety supplied as standard with in built obstacle detection, dual height and dual side photo-electrical beams, flashing light and warning sign.
A range of control options are available including access control, radio control or Vehicle detection loop system.
FINISH OPTIONS
Galvabond steel (standard).
Dulux Duralloy or Interpon D1000 powdercoat finishes are suitable.
Electro-static twin coat wet sprayed paint.
SPECIAL NOTES
The power supply required for the motor is either:
Single phase hard wired (10 amp), located within one metre of the motor.
Low voltage 24v wired supply, within one metre of the motor.
24v High efficiency solar power.
Work by others:
Power supply provision if required.
Structurally adequate footings / mounting points to support the gate.